How to maintain the SF6 Gas Leak Detector (WINFOSS- SF6在线监测系统_SF6检漏仪_SF6传感器_SF6密度继电器

韦弗斯新闻动态

最新动态

SF6安全保障专家

专注于SF6气体检测的专业化

135 85763546

How to maintain the SF6 Gas Leak Detector (WINFOSS-C1)

发布时间：2017-08-29 来源：ydlcb 浏览次数：40次

SF6 gas quantitative leak detector has high sensitivity, wide measuring range, advanced calibration method and high accuracy calibration line, which improves the reliability of SF6 leak detection results and the accuracy of quantitative leak detection. It is a necessary testing instrument for power supply departments, installation and maintenance units and electric power test research institutes. Based on years of experience, we have summarized some problems encountered in the use of SF6 gas quantitative leak detector, here to explain.

1. How long does SF6 gas quantitative leak detector need to be checked and maintained?

It is generally recommended that users check once every two years, and once every six months in special cases (when the air path pollution is serious).

2, SF6 gas quantitative leak detector generally charge how long? When do I need to charge? When does the charge end?

Each charge time varies according to the actual remaining power, generally less than 12 hours. When the power indicator is insufficient, it should be charged in time, and it is not appropriate to use up all the electricity to ensure the battery life. The charging circuit is equipped with an overcharge protection device. When the battery is sufficient, the charging indicator will change from red to green.

3, how to protect the sensor?

The built-in sensor of SF6 gas quantitative leak detector is protected by the probe protection chamber. When running, the protection chamber is automatically closed by the detector, so that the instrument is in the measuring state. Otherwise, it is automatically protected when the power is turned off

4. SF6 gas quantitative leak detector stagnates in the measurement process and then the data drops, why?

This is the sensor performing the gain regression function, that is, return to the previous test process for verification, at this time the interface data does not move, but the CPU is processing the data, so the data immediately drops after a while.

The above is the SF6 gas quantitative leak detector common problems and instructions, when we use this instrument in the test process, if you encounter the above problems, can be solved according to the above method, can not solve the manufacturer engineers to solve.